For this I took a piece of slightly textured cream paper, and stamped the large wording from the Elusive Images Medieval Heraldry u/m sheet at the top in Staz-on Timber Brown.I stamped this twice, one next to the other. Below this is stamped the script from Elusive Images Scripts & Timepieces u/m plate, also in Timber brown.This was stamped three times down the length of the paper below each of the large words. Over this I stamped the crowns and shield from the Heraldry plate. The shield was stamped in Adirondack Red Pepper, the crowns in Espresso, both second impressions.Tear the paper at roughly 8 cm wide down its length. I then used a colour duster to add some Terracotta ink in patches lightly over the design. I stamped the Knight in Copper Pigment ink,(Ink It Up) onto some cream hammer card and embossed with Stampendous Copper Detail powder.The sentiment was also stamped & embossed the same way. Cuttlebug folder ‘Forest Branches’ was used on a sheet of gold card cut to the width of the embossing folder, but twice the length. Because of the type of pattern, you can emboss half the card, then turn your card round and emboss the other half, just line up the pattern you have already embossed to the bottom of the folder.Trim down the image and matt onto black card, then onto the embossed card, leaving a wide border. Repeat with the sentiment, not leaving so much of a gold border. Black card was cut and folded to make a blank 10 1/2 cm x 20cm. The stamped script paper was then attached to the left side of the card blank with about 1cm folder around the back. The Knight was mounted with foam pads to the right hand side, and the sentiment added to the bottom. Red & Gold cord was wrapped around the spine and a red tassel added.